Hot Rod Forum banner

350 engine 85% complete with engine stand

3K views 0 replies 1 participant last post by  Roger Mabry 
#1 · (Edited by Moderator)
350 engine 85% complete with engine stand
*** SOLD ***

Used 350 (supposed to be four bolt mani), has great oil pressure but needs a valve job - determined by leak down compression test.

Was in my car until being pulled for ZZ4383 engine.
Figured if I had to do a valve job might as well go all the way!

Has starter, PS pump, front is complete with full size GM AC compressor (worked when removed) and alternator. Has Ram Horns and Edelbrock C3B instake just bolted on top. HEI distributor needs new module inside... Has small Isky cam, head work on the ports and had plenty of power - but not 410 HP and 470# torque of new 383!

Will sell the engine and include the stand and the engine plate bolted to the manifold - pick up
in So Cal - Glendora, CA. I have a engine hoist to lift it up into a truck or trailer.

Price is very fair for a almost complete engine/engine stand and special period intake...carb is on the new engine and I replaced the dead distributor (needs new GM module) with Mallory ignition...

Lowered price to $450.00 7/13/2013

Asking Price: $450.00
Condition: Good

Location (City, State, Country): Glendora,CA, USA
 
See less See more
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top