[lt1silverhawk]

Originally Posted by cobalt327

Go ahead and use the second set, no need to buy two sets.

Thanks, I ordered them a little while ago. Hopefully they'll show up this week and I'll install 'em this weekend.




On a related subject, I was looking up information on rebuilding cylinder heads and came across ac article that mentions PC and Viton seals. Not thing major but thought it was an interesting tid bit.

"Valve-guide seals are another important consideration. While O.E.M. seals do an adequate job, JGM prefers to use Viton rubber seals available through a number of sources including Fel-Pro. These seals are positive seals, meaning that the valve guide must be machined to allow the seals to fit properly over the guide. For more information on Viton seals, refer to “Oil Control” in the October ’93 issue of Hot Rod."


"Hot Rod Magazine: Heads Up! Rebuilding Cylinder Heads The Right Way": Image 14


Read more: Cylinder Head Rebuild - How To - Hot Rod Magazine