I was just looking for any information as to approach this project, any knowledge, tips or suggestions would be highly appreciated. By the way it is a 1995 Chevy S-10, standard cab, 2.2L 4-cyl eng., 5 speed manual trans. 2 wheel drive. Again any info would be appreciated.
We just had 1 of these come through the shop, head gasket blew. is the 5spd a tremec TK0 5spd, if so, it can be bolted to the 350, SBC into an S10 is not uncommon, and there are kits for it.
the 2.2L bellhousing is differant then a small block chevy's. from what i'm told, onlt the 4.3L has the same bolt pattern.
i've got a 94 that i'm starting on myself. 2.2L 5 speed, going to a 350 & automatic trans.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Hot Rod Forum
2.2M posts
175.6K members
Since 2001
A forum community dedicated to hot rod owners and enthusiasts. Come join the discussion about restoration, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!