Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 220 V issue
Thread: 220 V issue
View Single Post
  #4 (permalink)  
Old 10-31-2009, 09:36 AM
kleen56's Avatar
kleen56 kleen56 is offline
Registered User
 
Last photo:
Join Date: Oct 2006
Location: Santa Clarita CA
Posts: 802
Wiki Edits: 0

Thanks: 4
Thanked 6 Times in 6 Posts
Thanks for the info. I noticed they sell the plug and wire in 6 foot length specific for dryers. I could buy additional 10 gauge 220 wire and make an extension cord to my air compressor. I figure the cost with wiring and a plug will be about $60 which is better than $500. It'll be nice to be able to use my air tools again as well.
Ed

I'm confused now, I got this from an old post in here. The guy is a licensed electrician and quotes," It is a dangerous practice to run a plug on a circuit that it's not intended for such as putting a 30 amp drier plug on a 20 amp piece of equipment. This is a violation. You must use the correct plug for the circuit and not go over or under. I'm a licensed electrician by trade.[/QUOTE]

Last edited by kleen56; 10-31-2009 at 09:52 AM.
Reply With Quote