Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 305
Thread: 305
View Single Post
  #38 (permalink)  
Old 02-13-2013, 05:21 PM
Wezz Wezz is offline
the youngone
 

Last journal entry: progressthe
Last photo:
Join Date: Jan 2013
Location: holland
Posts: 369
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
hm..

Well I measured .. I borrowed the micrometer .. with dimensions of 94.9mm And should one have tollorantie of 2 hundredths I believe ... but there went that far over it as I see it .. at cylinder 7 is the correct one hundredth smaller .. vandaaar perhaps the scratches?

in each case .. I suggest not bounce him honing drilling. I only new piston springs and bearings should be sharpened crankshaft bearings where he touches.
Reply With Quote