Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 327 build help
Thread: 327 build help
View Single Post
  #42 (permalink)  
Old 01-04-2010, 01:33 PM
ap72 ap72 is offline
Last photo:
Join Date: Jun 2005
Location: St. Louis, MO
Age: 31
Posts: 9,544
Wiki Edits: 0

Thanks: 20
Thanked 404 Times in 377 Posts
Originally Posted by Rickracer
Not to pick on you, but while they look good, I would bet money those don't flow as much at .150 to .400 lift as a bone stock set out of the box, which is where the stock Vortecs with a GOOD valve job really shine. Got any flow numbers on them???
unfortunately, no. I have a few sets of heads I was going to take to my buddy's place all at once (he's two hours away), but with an upcoming wedding and house buying time is well... non-existant.

I'm curious though, what would you change? These were all taken before the valve job. The SSR is a hair flat at the top but I did my best to give it a good curve, they cc out right at 180. I would take some more of the current stuff i have but my camera was stolen when my truck was broken into.

If you could give me some details I'm all ears. I've talked to a few head porters for tips and tricks but I'm just the average joe. I design landfills for a living.
Reply With Quote