Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 327 power questions
View Single Post
  #15 (permalink)  
Old 09-01-2012, 09:33 PM
Malibusurfer Malibusurfer is offline
Registered User
 
Last photo:
Join Date: Aug 2012
Posts: 50
Wiki Edits: 0

Thanks: 3
Thanked 0 Times in 0 Posts
The 462 heads are what I have for now, but would eventually like to bump to aluminum's eventually...
The 462's have been ported pretty good and polished by reputable guy in my area... They are fresh cut to 2.02 /1.60 (from 194's) screw in studs, guide plates, etc... They are getting done right to handle the most they can flow for their vintage....
I'd really like to get to 6-6500 or more if possible just for some adrenaline or even take to track to see what she does in 1/4, but mainly truck is a street cruiser...
Am I limited to my high rpm's by cam and trans and rear setup??? Would a built 350turbo be a better deal??? Truck will not see lots of highway miles, but now and again......
Frame on truck is getting boxed in and crown Vic panther front suspension, etc... So chassis should be able to handle what I have for motor....
Reply With Quote