Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 350 build questions, looking for 300-350 hp
View Single Post
  #1 (permalink)  
Old 06-20-2011, 04:03 PM
Jaiden2010 Jaiden2010 is offline
Registered User
 
Last photo:
Join Date: Jun 2011
Location: Arizona
Posts: 5
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
350 build questions, looking for 300-350 hp

Hi. I have a tired 350 out of a 1991 3/4 ton truck block casting 10243880, heads 14102193. Since this is out of a 3/4 ton truck. I was thinking the heads are probably not the best flowing. I am replacing a dead 283 that I had in my 89 S-10 Blazer 2wd. I installed 3.73 gears. I have a set of V8 swap S-10 headers, Performer RPM intake, and a new VooDoo cam, these are just some new parts I have that were for purcased for a project I sold. I'd like to utilize them, any thoughts on the best route to go. Possibly what heads I should pickup from the boneyard? The block was inspected at the machine shop and does not to be bored, but should I have it punched out? I also have access to a 400 crank. I am not sure what way to go lol. I have a $1500 budget on building this motor. I will assemble it myself. I am shooting for 300-350 hp.
Reply With Quote