|
|
|
07-13-2006, 07:58 PM
|
||||
|
||||
|
350 head question for street engine on pump gas
I have 350 with flat top forged pistons -6.1cc , stock bore,276 cam 221/221 duration,454 lift.I think cr is 10:1 with 64cc heads,.about 9:1 with 76cc maybe a little less. Would 76cc be underpowered? What octane would work with 64cc aluminum?I have heard that with aluminum you run 1.0 higher on cr.I aslo saw aeroheads have 72cc heads.Any opinions appreciated
|
|
07-13-2006, 09:24 PM
|
|||||
|
|||||
|
To run high test pump gas with a mildly cammed street car.Keep compression to approx 9.5:1 or less with iron heads 10.5:1 or less with aluminum.
|
|
07-13-2006, 10:54 PM
|
||||||
|
||||||
|
did u see latest chevy hi pro mag
best heads under 1,000
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbo vs Supercharger - Write up!! | FastChevyTruck | Engine | 107 | 02-16-2011 12:18 PM |
| SBC 350 superiority rebuttle...was:POWERED BY CHEVY, WRITTEN ON A FORD, (from 'Engine | Oldsmolac911 | Hotrodders' Lounge | 50 | 01-12-2011 10:00 PM |
| Port or Full time vacuum | cool rockin daddy | Engine | 129 | 10-05-2010 03:00 PM |
| this is a saver.... GM build codes | TooMany2count | General Rodding Tech | 24 | 11-23-2009 09:36 AM |
| question on cam & oil pump install chev 350 | solowookie | Engine | 16 | 04-03-2002 04:25 PM |
