Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 37 Chev with Mustang II Alignment Question
View Single Post
  #50 (permalink)  
Old 12-03-2012, 10:41 PM
matts37chev's Avatar
matts37chev matts37chev is offline
I don't understand?
 

Last journal entry: Try again
Last photo:
Join Date: Jan 2009
Location: Shelton,Wa.
Posts: 2,485
Wiki Edits: 0

Thanks: 26
Thanked 20 Times in 19 Posts
Quote:
Originally Posted by timothale View Post
You can go the heidt's website and check out their installation instructions. A few years ago when Gary was in charge he had a lot of Mustang II engineering info on the site..If you down load their New catalog read pages 67 thru 69 most of the old stuff is there,
good stuff, that where these links go
Quote:
Originally Posted by matts37chev View Post
would just using tube type arms like these, give him enough clearance at the frame, to make the needed adjustments?

or maybe some narrowed upper arms like these shoved out to make room?
that page is right here
Reply With Quote