Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 4.5 bolt pattern for a '71 duster
View Single Post
  #3 (permalink)  
Old 08-13-2006, 07:58 PM
My-first-rat My-first-rat is offline
Registered User
 
Join Date: Aug 2006
Location: Lima,Peru
Posts: 14
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
4.5 bolt pattern for 71 duster

Hello Paulo,hello mopar neighbor,here in Lima there are only two or four in good shape and this one we are swaping a 383 B engine/727 tranny/ 8 3/4 rear end with 4.10suregrip combo for drag racing,by the way very incipient yet in Peru.But is a nice project almost done but for the front hubs is a pain you know were,jajaja.About the ford discs/hubs you're talking about a single piece unit non a two piece one like the mopar?.Well I found a couple of models and the spindle is too short for it in one case an is offset of the original four piston caliper of the car,that I dont want to swap because I already invested around $100 in repair them,but the fix goes in that way I think....I hope!By the way thank you very much for the advise and in wich state in Brazil do you live because I'm planning to go to Sao Paulo to visit a friend and see the F1 grand prix.
Reply With Quote