Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 400 horsepower with T5 gearbox
View Single Post
  #9 (permalink)  
Old 08-03-2012, 07:44 AM
ap72 ap72 is offline
Last photo:
Join Date: Jun 2005
Location: St. Louis, MO
Age: 31
Posts: 9,544
Wiki Edits: 0

Thanks: 20
Thanked 404 Times in 377 Posts
Originally Posted by 454C10 View Post
An old school 350 with 200cc dart iron eagle heads (64cc chambers). Compression is about 11:0 cr. I used a compcam 292H, edelbrock rpm intake, hei with msd ignition, holley 3310 750, long tube headers, dual 2.5 inch exhaust with hooker aero-chamber mufflers.

Put some foggers on the side of the intake under the carb. I used a 1 gallon fuel cell in front of the radiator to supply the no2 system with racing fuel.

gear is a 3.90 and slicks are 26x8 MT.

The compcam 292H will make power all the way to valve float (7200 rpms).

The block is zero decked and is actually 362 cids.

best so far on no2: 1.6 second 60 foot, 6.9 at 110 1/8 mile and 10.6 at 135 in the 1/4.

around 11.7 at 120 on the motor.
On a stock WC T5? Chevy or ford t5? Any mods done to it? I have two t5's to swap in cars when I'm done moving.
Reply With Quote