|
|
|
05-30-2006, 03:45 PM
|
||||||
|
||||||
|
400 sbc block 350 crank bearing spacers.
i had a set of the 377 sbc bearing spacers gave to me & i have a question. on the spacer itself, it has .010" on it. wouldn't they be standard size? why would the be .010" under? what am i missing? ***? wouldn't they need to be standard for a 350 type bearing to sit in them? the part number of the bearing he had for them is 7081chb f/m .011" under.
thanks 
|
|
05-30-2006, 05:30 PM
|
||||||
|
||||||
|
The bearing spacer was cut from a 400 bearing that was .010 under in its original state. We used to set up these used bearings in a straight 400 block and line bore them to 350 housing size. Then saw off the thrust sides, cut notches and ... Instant 350 bearing spacers!!
|
|
05-30-2006, 05:38 PM
|
||||||
|
||||||
|
thanks, i got to looking & i'm missing one lower spacer. i thought they looked like bearings. any way to replace just the one journal? thanks again
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 327 to 350 bearing spacers | jimfulco | Engine | 4 | 09-05-2007 09:37 AM |
| 350 block bored .080 with 400 crank ='s | savman1 | Engine | 6 | 03-14-2006 01:24 PM |
| Will 305 Heads Work On A 350 Or 400 Sbc ?? | STATUTORY GRAPE | Engine | 3 | 04-24-2005 08:10 PM |
| i need a better 400 sbc block | 406 ss monte | Engine | 5 | 06-21-2004 11:31 AM |
| 350 Block - Heads - Crank Combo | nightrain_rod | Engine | 0 | 07-06-2003 10:50 PM |
