|
|
|
02-10-2002, 04:31 PM
|
||||
|
||||
400s.b. est hp
i have a 400+.30 with edelbrock alum. heads flat top pistons9.75 comp.ratio my cam is 234-244 at.50 .488-510 lift. 5.7rods i have a edelbrock torkerII intake and a 750 vac.secondary holly.i'm putting it in a 77 datsun 280z with a turbo350 trans. 2800stall 3.48 gear the car weighs 2640 what kind of performance can i expect any help is greatly appreciated
|
|
02-10-2002, 05:08 PM
|
||||
|
||||
|
Sorry, i wouldnt want to guess, but it sure sounds like a fun ride . Have fun!
|
|
02-11-2002, 06:49 PM
|
|||||
|
|||||
|
I had to guess at the cam (my dyno asks for valve events, not duration) and also the exhuast (I went with small tube and mufflers). This is what I got: 414 hp @ 5440 and 439 tq @ 4480
I would guess high 11's with slicks <---just a guess!!! The Vandal
|
|
02-16-2002, 10:47 PM
|
||||||
|
||||||
|
My dyno program gets 394 HP and 369 TQ. These numbers are low for what you could get just by going to a little bit bigger cam (400's like to breath) and replacing the Torker II with a Victor Jr.
For et I get 11.79 @ 114 for the 1/4 mile <a href="http://www.virtualengine2000.com" target="_blank">Virtual Engine Dyno Software</a> [ February 17, 2002: Message edited by: RHamm1320 ]</p>
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
