Hot Rod Forum banner

427 Tall Deck intake manifold swap out

10K views 5 replies 3 participants last post by  BOBCRMAN@aol.com 
#1 ·
I'm looking for a aluminum intake manifold, to fit my tall deck without using spacers if possible. The heads are oval ports, and appeare to be original. I'm looking for either a single hi-rise, or something old school. I just cruise my car to show's, no long distant driving. Does anyone know of any Web sites out there?

Thank's

Mark
 
#6 ·
Dart lists a single plane. But not old school..

About the only economical way I know of is to use an old rectangle port intake and spacers. A slip collar distrib. If you use rect port gaskets everything will bolt up.. The super stock racers used rect port intakes on oval port heads back in the sixties and early seventies. I have seen oval port spacers a couple of times on Ebay. But they are rare.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top