Hot Rod Forum banner

47 Chevy engine mounts to tall!!!

1K views 3 replies 3 participants last post by  hogbreath73 
#1 · (Edited)
#4 ·
I want the frame level and it is. With these mounts I would
Have to raise the rear if the transmission 3 or 4 inches pushing it into the floorboard. Been doing some searching and chassis engineering make a set with biscuit style mounts instead of the angled ones. Maybe those will lower the front on the motor. I've got about 3 1/2 inches between the bottom of the motor and the crossmember, so I'll figure out something.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top