[BigRoy1978]

If you call speedway with the measurements they can find the EXACT U-joint you need. Super great people to work with!

[prostreet6t9]

Originally Posted by simcha1234

so i think their shud be a u joint i can buy which will be bigger to fit the yoke

The Pinion yoke looks to be a 1310 series joint. Spicer part# 5-153X

As far as the driveline... Is the joint held in by "inside" snap rings or outside snap rings?

If the D/L has inside snap rings use a Spicer 5-3022X

If the D/L joint needs to be wider but the caps are the same Dia as the pinion yoke.. Use Spicer 5-134X.

If those are not correct post the specs on what you need and I'll give you the part number.

[simcha1234]

I replaced the ujoint but one of the snap rings doesnt fit I guess the u joint is to big but it's so close to fitting on the driveshaft . the pinion yoke worked perfectly with the ubolt so what do I do now?

[prostreet6t9]

Originally Posted by simcha1234

I replaced the ujoint but one of the snap rings doesnt fit I guess the u joint is to big but it's so close to fitting on the driveshaft . the pinion yoke worked perfectly with the ubolt so what do I do now?

If a snap ring won't go in you better knock the caps back out and check for dropped needle brgs.

[simcha1234]

when I first put it that happend then I fixed it

[prostreet6t9]

Originally Posted by simcha1234

when I first put it that happend then I fixed it

Are you sure it didnt happen again? Did you happen to break one of the needle Brgs the first time it happened? If a needle brg broke there could be a small piece of the brg hanging things up.

[nine4gmc]

or could be a needle bearing in the opposite cap that was overlooked. If its really close fit, that would be the first thing i check, those bearings can be a biotch.