Hot Rod Forum banner

54 chevy with mustang2 front end

1K views 2 replies 2 participants last post by  8283hockey 
#1 ·
I have a 54 Chevy and installed a mustang 2 front end in it. I did not want it to be low in the front so I did not use the drop spindles in it. My problem is it is still to low . How can I pic the front end so it is not to low it hits the ground when I go over any bumps in the road ???????
 
#2 ·
If you didn't use dropped spindles it shouldn't be that low. It sounds you may have used springs that are a little too soft.

One question, are the lower "A" arms level with the ground? If they aren't the springs are most likely your problem.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top