Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 57 pontiac brake booster woes!
View Single Post
  #5 (permalink)  
Old 10-03-2011, 10:51 AM
cobalt327's Avatar
cobalt327 cobalt327 is offline
WFO
 
Last wiki edit: Intake manifold
Last journal entry: 1980 Malibu Wagon
Last photo:
Join Date: Mar 2009
Location: Atlanta
Age: 59
Posts: 5,037
Wiki Edits: 1616

Thanks: 128
Thanked 597 Times in 546 Posts
Quote:
Originally Posted by krazeyone
this master has 2 bleeder screws on it, one for the rear resivour and one for the front.
I'm guessing bates_k was looking at the severe angle the MC is at in the photo. If it were installed at that much of an angle and had any air in it, the air would be trapped far from the bleeders.

That's why I mentioned bench bleeding it before installation. Bench bleeding should always be done, but some guys will bench bleed the MC w/it on the car. In your case, this wouldn't be advisable, IMO. Instead, just carefully secure it in a padded vise or something along those lines (Workmate, perhaps?).
Reply With Quote