|
|
|
12-24-2012, 07:59 PM
|
||||
|
||||
|
66 Cyclone seems to sit uneven when measure the heights
I have a 66 Cyclone. When I measure from the ground the left and right wheel wells one side is 1/2 higher then the other. The tiers are the same size, the floor is level, all the supension parts are the same. When I place a level across the fender and over the shock towers it is level. I measured from inside fender to the uper control arm and one control arm is 1/2 inch higher. how do I fix this so all parts of my car is level. Ed
|
|
12-24-2012, 08:46 PM
|
||||||
|
||||||
|
You need to shim the low side to match the high side. The factory did not care about a 1/2 inch here or there!!
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Valve springs, heights and rates. ?? | RotorHead | Engine | 15 | 01-04-2011 07:11 AM |
| deck heights in an SBC | kc8oye | Engine | 33 | 12-30-2010 05:43 PM |
| Piston pin heights. | Hippie | Engine | 6 | 12-15-2009 08:16 PM |
| Question about spring installed heights | v8hed | Engine | 5 | 07-22-2008 05:28 PM |
| bbc intakes & heights | reegeemon | Engine | 5 | 01-27-2004 07:40 AM |
