[bigfoot9090]

hello everyone,

i have a 67 chevelle that i just got and the replacement front fenders and rear tail panel does not have holes for the emblems. does any one know what the location should be for the motor/flags, and rear chevelle emblem.


this is one of the best sites for info, i have used your site for tech info before and it was very helpful.

Thanks in advance

[MARTINSR]

You are right, this is a great site. However, for your Chevelle question I think you need to go over to the Team Chevelle site (Click here) the absolute without a doubt best site for Chevelle fans in my opinion.

Do you have the original panels that you could make a template off of?

Brian

[Crap Rod]

A Malibu or an SS ...
You can email me @ RickMiraski@msn.com
I own 1 or 2 Chevelles and Might be able to help ya out

[bigfoot9090]

its a malibu, any pics u have would help out alot. the one i am in most need of is the rear emblem where it says chevelle above the bumper by the tail light. the body shop i had that replaced the panel did not redrill the holes and trashed the old panel so i have no template, i did recover the front fenders so the painter drilled those holes for me, for the flags and motor decal.

thanks for your help

[crank18]

Hello bigfoot9090, I know this isnt a response to your question, but I've got a 66 chevelle malibu and I put two new rear quarter panels on and my body guy threw the old ones out, I am completly clueless where to drill the holes for my malibu emblems. I was just hoping you could help me out a bit. 66 and 67 chevelles had the emblems pretty much in the same position on the rear. I was wondering if your malibu has Malibu emblems on the two rear quarter panels and if you could maybe give me a few quick measurements on where abouts they are situated on the rear quarter panels? I'd help you out with your chevelle emblem on the rear tail panel but in 66 they just had that chrome peice with the plastic insert on the rear panel for the malibu.
Thank you very much,
Chris