Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 700R4 rebuild with wider low reverse roller clutch
View Single Post
  #1 (permalink)  
Old 01-02-2010, 02:09 AM
qwkswede qwkswede is offline
Registered User
 
Last photo:
Join Date: Nov 2007
Location: colorado
Posts: 52
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
700R4 rebuild with wider low reverse roller clutch

I'm starting to replace the old parts in my 700r4 with the fresh parts in my rebuild kit.

One of the first things I touched didn't seem to work right. I popped the roller assembly out of the low reverse carrier, and tried to install a new replacement one I got. The new one is wider than the old. Is this an "enhanced" part? My "kit" is a collection of higher performance parts from pro-built, and I guessed that this must be the case. But I can't get the snap ring back on with this wider part. There is only room in there for the original roller assembly.

Am I missing something here??



With the wider roller installed:
Reply With Quote