Hot Rod Forum banner

882 heads

1K views 6 replies 5 participants last post by  BuzzLOL 
#1 ·
These 882 heads came in today. Complaint was an engine miss.. These are pics of the exhaust seats.. Unlead gas again. The problem began when a previous rebuilder cut/ground thru the factory induction hardened seats. :spank:The valves pick up a small speck of seat material every time they open. Till the lifter runs out of travel, then the miss begins..

Another very expensive fix.. Valves,guides and seats.. I was amazed that the castings were not cracked:thumbup:
 

Attachments

See less See more
3
#4 ·
I'm amazed anyone would put the money into them unless racing a claimer class or some such deal forcing them to be used. :rolleyes:

Would be about the same cost to set up some decent budget offshore aluminum castings and make way more power.

the only good place for an 882 is on the end of an anchor chain LOL
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top