Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 9 inch ford
Thread: 9 inch ford
View Single Post
  #8 (permalink)  
Old 05-25-2004, 09:44 AM
mike bryan's Avatar
mike bryan mike bryan is offline
Member
 
Join Date: Jan 2003
Location: Fairbanks, AK
Posts: 62
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Thanks guys for your thoughts. I am sure that there are plenty of 9 inch ford rearends around fairbanks. This one is clean and ready to roll for the right application. Not alot of rodders up here in the far north and most of the projects and cars I am aware of are already built. I am one of the few who have a project going. I am not out anything on this rear except for a little acetylene, time and the cost of the flange ends. I may just store the housing for another project down the road. That is if I can make some headway with the current project. Thanks again. Mike
Reply With Quote