Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - 9 inch Ford disassemble procedure
View Single Post
  #1 (permalink)  
Old 04-03-2003, 04:43 PM
38 ford 4 door 38 ford 4 door is offline
New Member
 
Join Date: Oct 2002
Location: Roseburg, Oregon
Posts: 12
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Red face 9 inch Ford disassemble procedure

Before I start banging on my axle flange, is there anything I should know about any retainer rings inside? I am getting it ready to powder coat it and I dont want to ruin it taking it apart. It is a 28 spline 9 inch rearend with a standard carrier housing. Thank you for any information as I could not find anything covering this subject in the knowledge base.
Reply With Quote