Hot Rod Forum banner

98 350 vortec conversion

3K views 3 replies 4 participants last post by  blyne3 
#1 ·
Good Evening My problem that I am currently having is I am trying to do a vortec 350 conversion into my 98 Landrover Discovery and the engine I bought came with the Vcm and all the sensors however the wiring harness was cut at the engine and at the bottom of the Vcm so there is no harness to follow. I am currently trying to find a wiring diagram for the said engine and Vcm with the pin connections and so on so I can reroute and recreate the engine harness since I have some idea where the wires go but not the full picture. Any help on this situation would be greatly appreciated Thank you.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top