|
|
|
09-26-2006, 01:45 PM
|
|||||
|
|||||
|
Adjusting Vent Window on 1939 GM Body
The front vent windows on our 1939 Olds bind at the bottom of the new rubber vent seals that were installed by a window guy (who didn't finish the job and I'm not going back to him). The GM body manual indicates that the vertical position of the vent window can be adjusted by some screws that are under either the window moulding or the door panel.
Before I start trying to remove the new door panel, has anyone had any experience doing this? John 
|
|
09-30-2006, 09:25 AM
|
||||||
|
||||||
|
I have never done that specific car but all the ones I have done have been very easy to do. Pretty simple lo-tec process, you should be able to stumble thru it w/ little problem. Just do it.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| this is a saver.... GM build codes | TooMany2count | General Rodding Tech | 24 | 11-23-2009 09:36 AM |
| 72 chevelle vent window parts? | 73chevyhelp | Body - Exterior | 2 | 04-07-2004 03:55 PM |
| Wanted: 1959-1964 GM (caddy, buick, olds, etc) POWER VENT WINDOW MOTORS | KUSTOMRYDER | Hotrodders' Lounge | 0 | 03-15-2002 06:23 PM |
| Wanted: 1959-1964 GM (caddy, buick, olds, etc) POWER VENT WINDOW MOTORS | KUSTOMRYDER | Interior | 0 | 03-15-2002 06:22 PM |
| Wanted: 1959-1964 GM (caddy, buick, olds, etc) POWER VENT WINDOW MOTORS | KUSTOMRYDER | Electrical | 0 | 03-15-2002 06:21 PM |
