Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Is Adler a good machine brand?
View Single Post
  #10 (permalink)  
Old 02-04-2012, 03:27 PM
DanTwoLakes's Avatar
DanTwoLakes DanTwoLakes is offline
Hotrodders.com Moderator
 
Last wiki edit: Contact adhesive
Last journal entry: 49 Packard
Last photo:
Join Date: Apr 2006
Location: Lake Tomahawk, Wisconsin
Age: 65
Posts: 6,026
Wiki Edits: 22

Thanks: 0
Thanked 170 Times in 156 Posts
Quote:
Originally Posted by Qwerty27807
I was looking at a zipper foot to get close to the edge. The width of the foot seems like it would make it difficult to sew small seams. (I was hoping to make some backpacks and the like out of Cordura.)



The mounting of the feet to the machine seems to be oddball because the outside foot attaches to a round post, not a flat bar. I've found a couple on the internet, but they seem to cost triple what the "normal" industrial feet cost.

If you could post picture of cording foot zipper sewing, it would help.

Thanks.
The presser bar and the vibrating presser bar that hold the two pieces of the foot as well as the needle bar that holds the needle are all round shafts. They are called bars, but are not flat.
The zipper method with a welt foot is shown in post #14 of this thread: CLICK HERE
__________________
__________________________________

No one lives forever, the trick is creating something that will.
__________________________________
Reply With Quote