|
|
|
04-03-2012, 02:09 PM
|
||||
|
||||
|
Advice on solving exaust pipe issues
I have a small block chevy 350 stroker motor with a 671 blower dual 750 hollys, a tubo 400 trans, block headers with inch and seven eights primarys I have limited space and can not use 3 inch exahust pipe is two and half inch suitable?
|
|
04-03-2012, 02:26 PM
|
||||||
|
||||||
|
Not sure why you don't have room to put 3" pipes? If your running long tube headers, it should even be easier. With the 671 blower and what you have, I'd probably run 3". You can run 2.5" and it would OK, probably much quieter than with 3" pipes. I'd definitely go with some free flowing mufflers like Flowmaster, etc. That motor needs to breath!!!
|
|
04-03-2012, 08:44 PM
|
||||||
|
||||||
|
unless your running it into one 3'' pipe, 2.5'' duals will be plenty big.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cowl hood issues need advice/help | cudablack2004 | Hotrodding Basics | 4 | 09-13-2011 09:17 PM |
| Carb issues??? Advice required! | bygddy | Engine | 3 | 05-26-2011 05:29 PM |
| Carb issues, advice needed | DeputyDawg134 | Engine | 6 | 12-11-2007 12:42 PM |
| 4L60E issues - advice- maybe Crossley? | Tim240Z | Transmission - Rearend | 0 | 11-19-2005 09:29 PM |
| Exaust/Muffler Suggestions/Advice for blown Small Block | camaroman7d | Engine | 11 | 03-17-2004 04:32 PM |
