Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Air Gap vs. Weiand, Performer/RPM, Holley, etc. (again!)
View Single Post
  #10 (permalink)  
Old 12-05-2004, 06:44 PM
lluciano77's Avatar
lluciano77 lluciano77 is offline
Short changed on common sense
 
Last photo:
Join Date: Jun 2003
Location: california
Age: 37
Posts: 3,548
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally posted by GoneNova/406
i rember slightly looking that over when it came out but didn't pay that much attension,but thats too much difference.i'll go back in issues and look it up tonite and maybe get back to you tomorrow.i have an rpm and like it but like an original torker with 2 " spacer better.would like to get something else later.victor jr.,tork link,or you probably can't go wrong with proffesioal products and their edelbrock knock offs for so much cheaper.
You can go wrong with the Professioinal Products intakes. The casting isn't nearly as good. The port dimensions aren't as accurate.
Reply With Quote