op's original post
Quote:
|
Block was line bored .30 over and decked. the rotating assembly was balanced, forged flat tops,
|
I agree with what everyone's saying here about the crap heads, dog of a cam etc etc but did the machine shop really use re builder pistons with reduced height? op says forged so I doubt it but stanger things have happened. And when they decked the block surely they must have had a clue as to were the piston was going to end up in the hole, hopefully 0 to 0.015 give or take. So with any luck he can swap the cam, heads and intake as mentioned and get his power back.