Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - another vortec question
View Single Post
  #1 (permalink)  
Old 11-14-2012, 09:23 AM
oldworldnewtoys oldworldnewtoys is offline
Registered User
 
Join Date: Dec 2011
Location: United States
Posts: 9
Wiki Edits: 0

Thanks: 2
Thanked 0 Times in 0 Posts
another vortec question

hay guys im flip flopping on how i want to proceed with establishing proper installed spring height on my vortecs i all ready have a new set of valves with a height of 4.911 placing the spring installed height around 1.685 my new springs have a installed spec of 1.750 my question is do i get different valves as close to the right height (about +.050) as i can and cut the rest out of the seat (about .015) or do i get +.050 keepers and is that likely to cause problems with the roller tip rocker i have with the retainer and yes i know about the retainer to seal issue

thanks for the thoughts and wisdom you guys and this site are the best!!!!
Reply With Quote