Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Anti-Sieze on cutting burrs
View Single Post
  #1 (permalink)  
Old 08-30-2011, 03:24 PM
oldschool hero oldschool hero is offline
Registered User
 
Last photo:
Join Date: Dec 2010
Location: williamston sc
Posts: 319
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Anti-Sieze on cutting burrs

A few months back the question came up about clogging burrs when used on aluminum. Someone suggested using anti-sieze compound, well I just had some aluminum come in and had to do quite a bit of grinding on and recalled the suggestion, tried it and was very surprised how well this works.
What useually takes an hour was cut down to fifteen minutes.
Thanks to whoever it was.
Reply With Quote