[BAILEIGH]

I've seen a couple pics on the HAMB but nothing that is very tight.

[Shelby1]

I did this in my teens to made headers for flat head V8S.Brase a freeze plug in one end pack sand in the tube (from the sand bed in front of my house)weld another freeze plug, heat with a rose bud tip in the torch and bend around a old fire bottle. It was slow ,a lot of work and I could never get sharp bends to come out right. But I made enough of them to make enough cash to buy the parts that I needed for my motor.
God this is something that I have not thought about for a long time.If I were to build something along these lines today I would buy a couple of boxs of pre bent tubes and go to work building from them.
Much easier !!

Kenny

Lost your job yet?
Keep buying foreign.

[robs ss]

Just noticed your in Manitowoc, I'm in Two Rivers, just saying hi.

Rob

http://www.1969supersport.com

[BAILEIGH]

Originally Posted by robs ss

Just noticed your in Manitowoc, I'm in Two Rivers, just saying hi.

Rob

http://www.1969supersport.com

Right on!

Cool to see some local talent on the board.

[tinman386]

Fondulac WI here.

just wanted to also say hi to yous guys. lol

[BAILEIGH]

Originally Posted by tinman386

Fondulac WI here.

just wanted to also say hi to yous guys. lol

Hello. Snow today?

[robs ss]

Hi tinman

Rob

http://www.1969supersport.com

[4 Jaw Chuck]

Cerabend works better, melts out with boiling water.

[BAILEIGH]

Originally Posted by 4 Jaw Chuck

Cerabend works better, melts out with boiling water.

Have you ever heard of people bending mild steel of stainless with it?

[MARTINSR]

I have to tell you, I have tried the bending the tubing stuff, never again. Buy a kit with U bends and straight pipe and then just cut the U bend where you need it to make up your bent pipe. It works like a charm and looks WAY better.

Brian