Hot Rod Forum : Hotrodders Bulletin Board - Anyone ever used an "ATD" 6836 gravity feed spray gun?

Hot Rod Forum : Hotrodders Bulletin Board (http://www.hotrodders.com/forum/)

- Body - Exterior (http://www.hotrodders.com/forum/body-exterior/)

- - Anyone ever used an "ATD" 6836 gravity feed spray gun? (http://www.hotrodders.com/forum/anyone-ever-used-atd-6836-gravity-feed-spray-gun-53193.html)

STATUTORY GRAPE

12-01-2004 07:22 PM

Anyone ever used an "ATD" 6836 gravity feed spray gun?

I bought a used ATD 6836 gravity feed gun and was wondering if anyone could tell me the best way to adjust it for spraying acrylic enamel. It has a 1.4mm tip, this would be O.K. for enamel would it not :confused:

julmer

12-01-2004 11:34 PM

Looks like the typical Sata imported clone. About 25 psi at the gun, air control (next to the inlet) about 3 turns out, fluid control ( back of the gun) wide open, and fan (on the side) about midway. That should get you in the ballpark

STATUTORY GRAPE

12-02-2004 04:27 PM

O.K. I'll give that a try and see how it does. Thanks.

All times are GMT -6. The time now is 06:57 AM.