Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Aspiring trimmer, introduction and a few questions
View Single Post
  #10 (permalink)  
Old 10-05-2012, 09:36 PM
timothale timothale is offline
Registered User
 
Last wiki edit: General Motors transmissions Last photo:
Join Date: Mar 2006
Location: near Yellowstone park
Posts: 4,385
Wiki Edits: 27

Thanks: 12
Thanked 268 Times in 250 Posts
steaming seats.

I was an engineer at Ford for over 15 years, Had interior trim for a few years, In the factory they used super heated steam, Had booster heaters near the point of use, on most cars in the 60's and 70's they would use a steam hose thru the luggage compartment, poke the hose nozzel in the qtr roof area and steam for 30 to 40 seconds to remove headliner minor wrinkles. , in the seat build area they had a couple steam drops, seats only got steam when there were wrinkles.
Reply With Quote