Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Be aware of Low Cost, Low Quality Aluminum Heads
View Single Post
  #9 (permalink)  
Old 04-12-2006, 04:41 PM
machine shop tom machine shop tom is offline
King of my Man-cave.
Last photo:
Join Date: Nov 2003
Location: Michigan
Age: 58
Posts: 2,912
Wiki Edits: 0

Thanks: 6
Thanked 18 Times in 15 Posts
I checked out one of the heads I have here. The Engine Pro part# is PFS191202-2A. The part# is a tag that is suprimposed over another part# tag that reads (in part)C3002S>

The heads don't look bad. The valve job itself is among the best I have seen on aftermarket heads. The head I checked is warped .012", not unlike other aftermarket heads I have seen. The spark plug holes are washer-seat, with a 7/16" reach. They are unported, need bowl and port matching and clean-up.

That's all I have on them.

Reply With Quote