[william27103]

ok, sounds like i should know this with everything else i know, but what parts do you have to take to the machine shop to get the rotating assembly balanced. the crank, the rods, the pistons and what else, this is for a sbc 383 stroker.

Thanks

[killerformula]

crank, rods, slugs, flywheel. Take your harmonic ballancer too, have them check it out for the snout and rubber while they're at it-

K

[k-star]

1 set of rod bearings, rings, piston pins and locks (if needed)

keith

[killerformula]

^ didn't think of that, I usually buy that stuff from the machine shop anyway-

K

[machine shop tom]

Originally posted by killerformula
^ didn't think of that, I usually buy that stuff from the machine shop anyway-

K

You my kind of customer!

tom