Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Basic backwoods radius benders
View Single Post
  #2 (permalink)  
Old 03-22-2013, 08:04 AM
timothale timothale is offline
Registered User
Last wiki edit: General Motors transmissions Last photo:
Join Date: Mar 2006
Location: near Yellowstone park
Posts: 5,118
Wiki Edits: 27

Thanks: 35
Thanked 484 Times in 428 Posts
bowling ball ?

I have bowling ball and a smaller ball from a carnival game, I hollowed out wood smaller radius cavities by building an over arm jig for my table saw , a center point screw then raising the blade , hollow it out, drop the blade rotate the block. raise etc etc , using a 10 in blade and 7 in blade, A chain saw tooth carving blade for a 4 `1/2 grinder is fast for larger curves.
Reply With Quote