Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - beefing up engine stand
View Single Post
  #3 (permalink)  
Old 08-14-2011, 08:08 PM
matt167 matt167 is offline
Member
 
Last wiki edit: Ford axle ratio codes
Last journal entry: Rear Suspension
Last photo:
Join Date: Aug 2005
Location: Prattsville
Posts: 6,401
Wiki Edits: 31

Thanks: 2
Thanked 59 Times in 55 Posts
Yea, IIRC when the long block 350 was on it, it wasn't the sturdiest but was safe for the 2 hrs it was there. only on the stand to remove intake, oil filter adapter and water pump when my dad swapped engines in his '72 C10. really wasn't needed for his swap, but he thought we needed 1 for it... I'll go ahead and mod it/ pick up 2 new steel casters from TSC. I need it soon, and he'll more than likely need it for the 383 in his Charger when he gets the car repainted.. I'll post pics when I'm done. I think I have enough metal to do it all tomorrow.
Reply With Quote