Hot Rod Forum : Hotrodders Bulletin Board

Hot Rod Forum : Hotrodders Bulletin Board (http://www.hotrodders.com/forum/)
-   Interior (http://www.hotrodders.com/forum/interior/)
-   -   Bench seats for a 39 Buick Rod (http://www.hotrodders.com/forum/bench-seats-39-buick-rod-224306.html)

quantumspores 09-23-2012 03:28 PM

Bench seats for a 39 Buick Rod
 
Hi Folks,

I'm in the process of building a hotrod out of a 39 Buick Special. I want to put a bench seat in the back and two bucket seats in the front. Can anyone provide any recommendations for for a rear bench seat that is between 46-48" wide? I've searched the salvage yards but really haven't found anything that I want to have reupholstered. At this point I would like to find an aftermarket "replacement seat" for something in that size.

Thanks!

schlock rod 09-23-2012 08:43 PM

I have a friend with a '39 Dodge 4 dr sedan, and he put the front and rear seats from an Acura in it. The rear seat really fit good width wise, and only needed a little fabricating around the edges to blend in with the rest of the car. Check out the foreign jobs, as a lot of them are going to be really close to what you need.

Schlock Rod

DanTwoLakes 09-24-2012 07:57 AM

The rear seats from most newer cars, especially the smaller ones, are form fitted to sit right on the floor and do not have much support. You're going to need something like a middle seat from a mini van to adapt to the back of your car.


All times are GMT -6. The time now is 05:00 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.