Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Bending Exhaust pipe
View Single Post
  #7 (permalink)  
Old 05-30-2004, 02:28 PM
cboy's Avatar
cboy cboy is offline
Member
 

Last journal entry: Finished
Last photo:
Join Date: Jan 2004
Location: Atwater, CA
Age: 69
Posts: 3,915
Wiki Edits: 0

Thanks: 0
Thanked 2 Times in 2 Posts
Quote:
Originally posted by 84_sportcoupe
it worked, but i wouldnt want to do it again.
What problems did you run into that would prevent you from doing it again? I have a project in mind (non-exhaust obviously) that would require a bend with about a two foot radius. Would this be doable with the sand in the tube technique?
__________________
Always learning...and sharing what I've learned. The Scratch-Built Hot Rod.
Reply With Quote