Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Bending tailpipes
View Single Post
  #13 (permalink)  
Old 03-21-2012, 05:47 PM
rsfyj rsfyj is offline
Registered User
 

Last journal entry: My Last Hot Rod
Last photo:
Join Date: Oct 2011
Posts: 264
Wiki Edits: 0

Thanks: 15
Thanked 1 Time in 1 Post
probably 20 alone on the headers

i used 1968 390 headers and had to make dog legs for clutch linkages and bell housings etc none of you know what I ran into here duals over the axel were different all the way through. You just don't know I made the header adaptors from the headers to the mufflers all of it everything except the header flanges I didnt have to modify. I can see know most of you never had a real challenge yah all had the right stuff to begin with, eheheheheh. All made from 2 sections of straight pipe i made all the bends with a hack saw and gas welds. no tubing cutters or power hack saws no mig welders all the old way.. eheheheh
Reply With Quote