Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Big Block Head choice 781s or .......
View Single Post
  #5 (permalink)  
Old 10-10-2003, 05:06 PM
unstable's Avatar
unstable unstable is offline

Last journal entry: Brackets, Stories and the future
Last photo:
Join Date: Feb 2003
Age: 38
Posts: 743
Wiki Edits: 0

Thanks: 2
Thanked 4 Times in 4 Posts
oh sorry...I was wrong, your casting sucks. sell them to me.

Ok here's what the book says:


are all hot castings.

These castings were originally equipped with 2.06" intake and 1.72" exhaust valves. FOr high performance use, these heads are routinely fitted with 2.19" intake and 1.88" exhaust valves.
The little...very little information about the heads was about the most useful information in this POS book I got. It goes on to talk about rectangular port heads...and says that for anything less than full-tilt racing they suck and do not flow as well at lower RPMs as the above listed heads.

HTH bro.
Reply With Quote