[Kampr]

I have one of the HF blast cabinets and the gun went bad. I'm looking to buy one and wanted to know if any of you guys have used this one and what you think about it.

http://www.tptools.com/p/2189,22_Tri...Power-Gun.html

I'd rather spend less than this but not at the expense of quality. Any other suggestions? It is made in the USA so that's one plus for it.

[JohnnyK81]

I just use a CH gun.. Works fine for me. Does get tiring though after a few minutes.

[rdupree]

I have a complete TIP blast cabinet setup. Really like their products. In my case, I have a foot air control so I can use a slightly cheaper version of their gun that does not have the air valve built in.

Be sure to get a package of extra ceramic nozzles when you order the gun. The standard steel nozzle probably won't last too long. Also, keep a good eye on the condition of the air nozzle whenever you change the sand nozzle. As the air nozzle wears, it will change the flow pattern of the sand inside the head and wear the head out quicker. Again, nice thing with the TIP unit, the front part of the gun with the nozzles is a replaceable item.

[Kampr]

I'll probably get the one from TP tools. There are probably some good cheap guns out there but I would probably choose the bad one.