Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Borg-Warner R10 Overdrives?
View Single Post
  #15 (permalink)  
Old 03-15-2005, 12:55 AM
packratwrecker's Avatar
packratwrecker packratwrecker is offline
Too many hobbies!
 
Last photo:
Join Date: Dec 2003
Location: Kansas
Age: 41
Posts: 240
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Leo,
I never considered that this might be a Chevy unit, for an old torque tube setup. That would explain the flange and collar on the back end, and the strange output shaft spline. It's 1 3/16"(or 1 3/8", have to measure again) x 10 spline. I got the output yoke from a Jeep & 4x4 shop, down in Salina.

The rear shaft is from a 64 Chevy pickup. I only had to cut a little of the spline stubs, to get the lengths right. It's basically reversed position, with the carrrier bearing cut off. I can't remember where I got the front shaft, but I think it's a 4x4 front shaft, given the small diameter tube.

That is the problem with being a packrat. I can dig up almost anything, but most of the time I can't remember where I got it, or what it fit.
Reply With Quote