Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Building a door dolly?
View Single Post
  #21 (permalink)  
Old 03-13-2012, 06:30 PM
e-tek's Avatar
e-tek e-tek is offline
www.E-tekRestorations.com
 
Last photo:
Join Date: May 2008
Location: SK, Canada
Posts: 19
Wiki Edits: 0

Thanks: 0
Thanked 2 Times in 1 Post
Quote:
Originally Posted by gow589
I don't think you could move a door up or down a 1/16" with a bumper jack. I have never ad a problem moving the door in small increments. With the bolts snug, loosen, minor adjustment, tighten done.
No offense, but you haven't done a lot of doors then. Often if they are hanging from the bolts and you loosen them without any support they will fall too far. It's also VERY hard to move doors up - at all or evenly - without some support under them. I've installed and adjusted MANY doors over 35 years in the biz - there are reasons people are making jacks and stands....
Reply With Quote