Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Can I reverse shrink, by doing this?
Thread: Can I reverse shrink, by doing this?
View Single Post
  #3 (permalink)  
Old 11-01-2006, 07:49 PM
baddbob baddbob is offline
Member
  
Last photo:
Join Date: Jan 2005
Location:
Posts: 3,707
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
quench on the same side, if you shrink it too far and take to much of the crown out of the panel you'll need to hammer some crown back in. Sometimes you can use a rubber mallet or plastic mallet or a wooden mallet so you don't get any hammer marks.
Reply With Quote