Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Carb Spacers
Thread: Carb Spacers
View Single Post
  #5 (permalink)  
Old 07-24-2007, 02:06 PM
techinspector1's Avatar
techinspector1 techinspector1 is offline
Senior Curmudgeon
 
Last wiki edit: DynoSim combinations Last photo:
Join Date: Oct 2005
Location: Hemet, California, USA
Age: 72
Posts: 12,565
Wiki Edits: 326

Thanks: 698
Thanked 877 Times in 745 Posts
Quote:
Originally Posted by BIGSKY
I installed a Moroso "plastic" 4 hole spacer on my SBC because I was getting heat sink into my Edelbrock. I don't know if it makes more torque because I changed exhaust at the same time, but it did solve the heat sink problem.
Good point BIGSKY. The most efficient spacer I've seen to prevent heat transferred to the carb is one made from wood and sealed with "bar finish" epoxy.
Reply With Quote