Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - carbide burrs
Thread: carbide burrs
View Single Post
  #11 (permalink)  
Old 10-13-2005, 09:07 AM
oldred oldred is offline
Last photo:
Join Date: Jan 2003
Location: tennessee
Posts: 5,927
Wiki Edits: 0

Thanks: 0
Thanked 10 Times in 10 Posts
Power, You make a VERY good and often overlooked point about those "cheapie" diegrinders. A lot of guys point to the fact that they seem to last a long time and cost next to nothing but there is a heck of a lot more to it than that, as you pointed out. A lot of times a failed burr will get the blame when it is the power tools fault and after breaking just a couple of burrs that "bargain" grinder is not such a bargain after all!
Reply With Quote